Mikro mosfet II - JeffTron

Professionally designed mosfet designed for AEGs.
The device increases the cadence of the weapon and the endurance of the battery compared to the original cabling in the weapon

SPECIFICATIONS:
- Very small device size, fits almost anywhere
- Separate device without cables, for power circuit cables with max. Cross-section 1.5 mm2 can be used and for signal circuit with max. Cross-section 0.5 mm2
- Suitable for service centers, if you are not sure about soldering the wires to the board, choose the variant with cabling and accessories.
- Designed for springs up to m160 (corresponds to a current of 75A for a single shot or 25A dose firing for a maximum of 30s). For higher loads, choose Mosfet II
- Designed for all types of commonly used batteries up to 17 V (Ni-xx 8.4 - 12V, lipol 7.4 - 14.8V)
- 5-wire connection
- the positive wire is not connected to the device
- Device size 15x7x5mm
- The trigger contacts do not burn
- No quiescent current is being drawn
- Due to the principle of operation of the AEG weapon mechanism, the piston stops in a random position in AUTO mode
- For the correct function of this device, it is necessary to have a functional interrupter, switch slide, reversing latch, trigger and trigger stop (locked) in the gearbox, ie as in the standard gearbox

PACKAGING: equipment, tube and installation manual

WARNING: To install this device, you need an expert who must be able to solder and disassemble the AEG weapon. Never use a transformer solder!